Jonsered 670,625,630 after market 52 and 50 mm cylinder kits

This kit will work on the Jonsered 670,625,630

AS always I only sell what I would use in my saws which I use to cut wood to heat my house with.

If you encounter any problems along the way, I am here to help you through it.

This is a conversion kit includes 50 or 52mm cylinder kit, wrist pin bearing ,base gasket, carb gaskets, exhaust gasket and all other item in the picture that are in yellow . Not eon the 52 mm kits , I am now adding an exhaust shield. this will help shield the cylinder from muffler heat.

I also include a work shop manual via email.

To avoid this happening again, use fresh premium gas which is less than 60 days old. Use an oil mix rated FD and a gas can with a tight seal. This will insure the least amount of water dissolved in the gas and the most lubrication possible.

Price includes shipping
50 mm cylinder THIS WILL FIT MOST 630 SAWS SEE BELOW FOR EXCEPTIONS

OR GIVE THE 630 IT MORE POWER WITH THE 52 MM CYLINDER.Plush a heat shield

50 mm cylinder THIS WILL FIT MOST 670 AND 625 SEE BELOW FOR EXCEPTIONS

OR GIVE THE 670 OR 625 MORE POWER WITH THE 52 MM CYLINDER. Plush a heat shield

For shipping out side of the USA , use these buy now buttons as they include the extra shipping
50 mm cylinder THIS WILL FIT MOST 630 SAWS SEE BELOW FOR EXCEPTIONS

OR GIVE THE 630 IT MORE POWER WITH THE 52 MM CYLINDER. Plush a heat shield
50 mm cylinder shipping to another country
OR THE 52MM cylinder Kit shipping to another country

EXCEPTIONS

I will also send this work shop manual so you can do this right.
Click here for my home page